Husqvarna 562 XP G Workshop Manual - Page 26
Replacing a broken or worn starter, 3 Tensioning the return spring
View all Husqvarna 562 XP G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Repair instructions 7.2 Replacing a broken or worn starter cord When the starter cord is worn and must be replaced, the tension in the return spring must be released. 1 Pull the cord out about 30 cm and lift it into the notch on the outside of the starter pulley. Release the tension on the return spring by allowing the starter pulley to rotate slowly backwards. WARNING! If the spring tension is activated on the starter pulley, the spring can fly out and cause personal injury. Wear protective glasses. 2 Loosen the screw in the centre of the pulley and remove the pulley. See figure 3a. 3 When the starter pulley is removed, insert a new starter cord and attach it to the starter pulley. Thread the other end of the starter cord through the hole in the starter housing and starter handle and tie a double knot on the cord. Wind approx. 3 turns of the starter cord on the starter pulley. Turn the starter pulley until it latches into the correct position. Tighten the screw at the centre of the starter pulley, at a tightening torque of 2-3 Nm. Cleaning and inspection: • Clean and check carefully all components. Worn or damaged parts must be replaced. Lubricate the return spring with a light oil. Fig 3b 7.3 Tensioning the return spring 1 Pull the starter cord up into the notch in the starter pulley and turn the pulley about 3 turns clockwise. Check that the pulley can be turned at least a further 1/2 turn when the starter cord is pulled all the way out. See figure 4. Fig 4 2 Stretch the line with the handle. Remove your thumb and let the cord spin back. See figure 5. 26 - English Fig 5