Husqvarna 562 XP G Workshop Manual - Page 39
If necessary, the lever arm can be bent, see
View all Husqvarna 562 XP G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
4. Assemble needle valve M with lever arm Q, shaft L and spring R, and tighten screw P. (Fit the expansion washer). See figure 40. Repair Instructions Fig 40 5. Check using a ruler or the like that the lever is level with the assembly plane on the cover. If necessary, the lever arm can be bent, see figure 41. Fig 41 7. Fit gasket K, the control membrane J and the pump cover H. See figure 42. 8. Carry out a pressure test. Fig 42 H J K English - 39
English -
39
Repair Instructions
4. Assemble needle valve M with lever arm Q,
shaft L and spring R, and tighten screw P.
(Fit the expansion washer). See figure 40.
5. Check using a ruler or the like that the lever is
level with the assembly plane on the cover.
If necessary, the lever arm can be bent, see
figure 41.
7. Fit gasket K, the control membrane J and the
pump cover H. See figure 42.
8. Carry out a pressure test.
Fig 41
Fig 42
K
J
H
Fig 40