Husqvarna 562 XP G Workshop Manual - Page 44

Repair Instructions 7.18 Replacing the fuel filter NOTE! Fluted pliers may not be used with the fuel hose. They can cause material damage resulting in damage to the fuel hose. 1 When replacing the fuel filter, the old fuel filter must be taken out of the tank unit using special tool 502 50 83-01. 2 Pull out fuel hose B from the tank unit and pull away the filter A. See figure 58. 3 Fit the new fuel filter A and press the fuel hose back into place. 7.19 Replacing the fuel hose/return hose The fuel hose is moulded and can only be removed from outside of the fuel tank. Use suitable pliers with a smooth cutting face and loosen the hose B from the fuel tank. See figure 58. Replace the return hose when required. Tighten the fuel hose on the filter side with your fingers. Fig 58 7.20 Replacing the fuel pump (Purge) Dismantle 1. Dismantle the cylinder cover and the air filter. 2. Loosen suction hose C and return hose from the fuel pump. See figure 59. 3. Snap off the fuel pump from the filter holder. Assembling 1. Snap the fuel pump in place in the filter holder. See figure 59. 2. Fit the return and suction hose on the fuel pump. 3. Assemble the air filter and cylinder cover. Fig 59 44 - English