Husqvarna 562 XP G Workshop Manual - Page 42
Tank unit, 16 Venting the fuel tank
View all Husqvarna 562 XP G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Repair Instructions 7.15 Tank unit WARNING! The fuel used in the chain saw has the following hazardous properties: 1. The fluid and its vapour are poisonous. 2. Can cause skin irritation. 3. Is highly inflammable. Dismantling 1. Drain the fuel from the tank. 2. Remove the cylinder cover, the clutch cover, the chain and the bar. See the Operator's Manual. Dismantle the carburettor as outlined in "Dismantling the carburettor". 3. Loosen the hoses A to D. See figure 50. 4. Loosen the screws F. See figure 51. 5. Loosen the movement limiter H. See figure 53. 6. Pull out the hoses A to D in the bottom of the carburettor compartment. Unhook the throttle cable, E, from the intake bellows before pulling out from the bottom of the carburettor compartment. Fig 50 NOTE! Exercise care so that the fuel hose and throttle cable are not damaged. 7.16 Venting the fuel tank The two-way valve has the following properties: • Controlled opening pressure in both directions, which prevents a positive pressure or a vacuum developing in the fuel tank and impairing engine performance. This also prevents fuel leakage. • Opening pressure outward 100-450 mbar. • Opening pressure inward (vacuum) max. 70 mbar. (2 locations) Fig 51 Test Opening pressure outwards: 1. Open the tank lock and leave it open during the entire test. Drain the fuel from the tank. G 2. Loosen the positive pressure hose as outlined in figure 54. Connect the pump, ref. no. 531 03 G 06-23, to the tank valve J. 3. Switch the pump to vacuum mode. 4. After pumping the indicator should be between 10-45 kPa. Fig 52 Opening pressure inwards: 1. Open the tank lock and leave it open during the entire test. Drain the fuel from the tank. 2. Loosen the positive pressure hose as outlined in figure 54. Connect the pump, ref. no. 531 03 06-23, to the tank valve J. 3. Switch the pump to pressure mode. 4. After pumping the indicator should stop at max. 7 kPa. Fig 53 42 - English