Husqvarna 562 XP G Workshop Manual - Page 31

7.9 Assembly of centrifugal clutch 1 Insert the clutch springs on the side of the shoes without text. See figure 17. 2 Screw in the clutch (anti-clockwise) until it stops. Then tighten the clutch using tool 575 25 14-01 and a suitable socket wrench or combination spanner. Tightening torque of at least 25 Nm. 3 Remove the piston stop and fit the spark plug using a tightening torque of 20 Nm and the spark plug hat. Then fit: • The cylinder cover • The bar • The chain • The clutch cover Fig 17 7.10 Dismantling the oil pump and screen 1 Empty and clean the oil tank. Dismantle the centrifugal clutch as outlined in "Dismantling the centrifugal clutch". 2 Loosen the clutch drum, the drive sprocket, the needle bearing and the pump drive wheel. See figure 18. 3 Unscrew the chain guide plate. See figure 19. 4 Loosen the screws on the oil pump from the crankcase and remove it together with the oil pressure hose. See figure 20. Cleaning and inspection • Clean and check all parts carefully. Parts must be replaced if cracked or showing signs of other defects. Always use original spare parts. • Lubricate all moving parts with chain oil. Fig 18 Fig 19 Fig 20 Repair Instructions English - 31