Husqvarna 562 XP G Workshop Manual - Page 48
Pressure testing the cylinder - chainsaw
View all Husqvarna 562 XP G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Repair Instructions 7.23 Pressure testing the cylinder 1 Loosen • The cylinder cover • The carburettor 2 Attach the cover plate 574 71 14-01 and plug 574 70 12-01. See figure 66. Fig 66a 3 Loosen the screws on the muffler and press the cover plate 575 29 05-01 between the muffler and cylinder. Tighten the screws for the muffler. See figure 66. Use the plastic piston stop 575 29 36-01. 4 Screw the pressure test connection 503 84 40-02 in place. Connect tool 531 03 06-23 to the nipple. Fig 66b 5 Pump the pressure up to 80 kPa (0.8 bar). Wait 30 seconds. The pressure should not be less than 60 kPa (0.6 bar). Remove the cover plates from the silencer and carburettor, tighten the bolts to the specified torque. Remove the pressure test nipplleand refit the spark plug. Fig 67 WARNING! Once the cylinder has been pressure tested, make sure the inlet manifold is fitted correctly. Otherwise the chainsaw can be damaged. 48 - English