IBM 79856au Installation Guide - Page 90
Problem, Diagnostic, Service, Guide, Determination
UPC - 883436004374
View all IBM 79856au manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
LED DASD RAID FAN TEMP BRD PCI Problem Action A hard disk drive has failed or has been removed. Note: The error LED on the failing hard disk drive is also lit. 1. Reinstall the removed drive. 2. Reseat the following components: a. Failing hard disk drive b. Hard disk drive backplane c. Disk drive cable d. (Trained service technician only) System board 3. Replace the components listed in step 2 one at a time, in the order shown, restarting the server each time. A RAID adapter has indicated fault. 1. See the BMC log or the system-error log (see "Error logs" in the Problem Diagnostic and Service Guide). 2. Reseat the following components: a. RAID adapter b. Hard disk drives c. (Trained service technician only) System board 3. Replace the components listed in step 2 one at a time, in the order shown, restarting the server each time. A fan has failed, is operating too slowly, or has been removed. The TEMP LED might also be lit. 1. Reinstall the removed fan. 2. If an individual fan LED is lit, replace the fan. A system temperature or component has exceeded specifications. Note: A fan LED might also be lit. 1. See the BMC log or the system-error log (see "Error logs" in the Problem Determination and Service Guide for the source of the fault). 2. Make sure that the airflow in the server is not blocked. 3. If a fan LED is lit, reseat the fan. 4. Replace the fan for which the LED is lit. 5. Make sure that the room temperature is not too high. See "Features and specifications" on page 4. 6. Call for service. An error has occurred on the system board. 1. Check the LEDs on the system board to identify the component that is causing the error. 2. Check the system error log for information about the error. An error has occurred on a PCI bus or v Check the LEDs on the PCI slots to identify the component on the system board. An additional that is causing the error. LED will be lit next to a failing PCI v Check the system error log for information about the error. slot. v If you cannot isolate the failing adapter through the LEDs and the information in the system error log, remove one adapter at a time from the failing PCI bus, and restart the server after each adapter is removed. v Call for service. 76 IBM System x3655 Type 7985: Installation Guide