IBM 8840 Installation Guide - Page 36
Completing, installation
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Retainer bracket d. Slide the flange of the heat sink into the opening beneath the retainer bracket. e. Press down firmly on the heat sink until it is seated securely. f. Attach the heat sink to the microprocessor by rotating the heat-sink lever to the closed position and hooking it underneath the lock tab. 7. Install the air baffle. 8. If you have other options to install or remove, do so now. 9. Replace the top cover. Go to "Completing the installation." Completing the installation Complete the following steps to complete the installation: 1. Install the top cover. 2. Install the server in a rack. See the Rack Installation Instructions that come with the server for complete rack installation and removal instructions. Attention: v Install the server only in a rack cabinet with perforated doors. v Do not leave open spaces above or below an installed server in the rack cabinet. To help prevent damage to server components, always install a blank filler panel to cover the open space and to help ensure proper air circulation. See the documentation that comes with your rack cabinet for more information. v Install the server in a rack that meets the following requirements: - Minimum depth of 70 mm (2.76 in.) between the front mounting flange and the inside of the front door - Minimum depth of 157 mm (6.18 in.) between the rear mounting flange and the inside of the rear door - Minimum depth of 718 mm (28.27 in.) and maximum depth of 762 mm (30.00 in.) between the front and rear mounting flanges 3. Connect the cables and power cords. See "Connecting the cables" on page 23 for more information. 22 IBM xSeries 346 Type 8840: Installation Guide