Icom IC-M424G Instruction Manual - Page 92
Troubleshooting
View all Icom IC-M424G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
11 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION REF. The transceiver does • Bad connection to the power source. not turn ON. • Check the connection to the transceiver and p. 76 power source. Little or no sound comes • Squelch level is set too high. from the speaker. • Volume level is set too low. • Speaker has been exposed to water. • Set the squelch to the threshold point. p. 11 • Set the volume to a suitable level. p. 11 • Remove the water with the AquaQuake func- p. 15 tion. Transmitting is impossi- • S ome channels are restricted to low power • Change channels. ble, or high power can- or receive only by regulations. not be selected. • The output power is set to low. • Push [HI/LO] to select high power. pp. 9, 10, 83 p. 12 Scan does not start. • Favorite channels are not entered. • S et the desired channels as Favorite chan- p. 17 nels. No beep sounds. • Beep tones are turned OFF. • T urn ON the beep tones in the CONFIGURA- p. 71 TION menu. Distress calls cannot be • M MSI (DSC self ID) code is not entered. • E nter the MMSI (DSC self ID) code. p. 7 transmitted. Built-in GPS receiver is • T he built-in GPS antenna is covered by an • M ount the transceiver in a place where no p. 78 not receiving valid posi- object that interrupts the GPS signals from objects interrupts the satellites signal. tion data. the satellites. (For only IC-M323G and IC-M324G.) 82