Intermec PF4i PF2i and PF4i Mid-Range Printer User's Manual - Page 65
To con the printer to use WPA or WPA2 Enterprise mode, Connecting the Printer
View all Intermec PF4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 2 - Connecting the Printer 2 Send one of the following WPA/WPA2 ON commands to turn on WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared key: setup "wlan","WPA","OFF" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","xxxxxxxxxx" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" where xxxxxxxxxx is a value between 8 and 64 characters. To configure the printer to use WPA or WPA2 Enterprise mode 1 Send the following commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. To enter non-alphanumeric octets, use "%nn," where nn is two hexadecimal digits representing the value of the character Note: The default password for logging in as an admin is "pass." If you have changed the password, you need to use your password instead of "pass." 2 Send one of the following WPA/WPA2 ON commands to set up WPA-802.1x or WPA2-802.1x authentication. You should also send the WPA_PSK command that does not contain a value: setup "wlan","WPA","OFF" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","" setup write "wlan","uart1:" To view the 802.1x values, send this command: setup write "8021x","uart1:" PF2i and PF4i Mid-Range Printer User's Manual 51