JVC DT-3D24G1U DT-3D24G1U Operation Manual - Page 15
Split, Lr Seq., R Shift, Anaglyph, Individual, Lr Swap, R
View all JVC DT-3D24G1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
SPLIT L image is displayed on the left of the SPLIT line, and R image on the right. You can check the difference between the images from the two cameras. LR SEQ. Images for the left and right eyes are displayed alternately at 0.5-second interval. ● A marker appears on the upper part of the screen, which distinguishes between L and R images. L image: Upper left R image: Upper right R SHIFT L and R images are overlapped. You can move the R image horizontally and check the difference between the images. ● While "R SHIFT" is active, the images are corrected according to the check using the circular polarizing glasses. ANAGLYPH L and R images colored red and blue separately are overlapped. You can move the R image horizontally and check the difference between the images. L image R image L H line SPLIT line L image R image L R L R H line 0.5 sec. 0.5 sec. 0.5 sec. 0.5 sec. L and R images not correspondent L and R images correspondent INDIVIDUAL Either L image or R image is displayed. ● Each time you press SELECT button, the picture changes in the following order. ● A marker appears on the upper part of the screen, which distinguishes between L and R images. L image: Upper left R image: Upper right LR SWAP L and R images are exchanged and then displayed. You can exchange the images without repluging the terminals. ● The setting is retained even when the menu closes. Note that L and R images have been exchanged when the setting is set to "ON." L image SDI IN SDI IN 1/L 2/R LR SWAP "OFF" R image SDI IN SDI IN 2/R 1/L LR SWAP "ON" POSITION knob/PUSH SEL. button You can move the displayed SPLIT line/H line/R image (only in "R SHIFT" or "ANAGLYPH") by turning the POSITION knob. To move right/up: Turn the POSITION knob clockwise. To move left/down: Turn the POSITION knob counterclockwise. To select a line to move: Press the PUSH SEL. button. ● Pressing and holding the PUSH SEL. button for 3 seconds or longer resets the lines and R image to the default positions. ● The intensities of the SPLIT and H lines can be changed in "L. INTENSITY" under the MAIN MENU "3D SETTING." (→page 19) 15