JVC DT-3D24G1U DT-3D24G1U Operation Manual - Page 17
Grid mode, NEAR LIMIT under the MAIN MENU 3D SETTING.
View all JVC DT-3D24G1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
● In Cursor mode, the lines of the following two groups are displayed: Group A: L line/R line/H line (Normal: Green / Over the LIMIT: Red) Group B: L line/R line/H line (Normal: Magenta / Over the LIMIT: Orange) • You can change a group to display by pressing the SELECT button. Each time you press the SELECT button, the group changes as shown on the right. • The line color turns to a color to be used when the LIMIT is exceeded when it goes beyond "FAR LIMIT" or "NEAR LIMIT" under the MAIN MENU "3D SETTING." ● You can move the L, R, and H lines by turning the POSITION knob. To move right/up: Turn the POSITION knob clockwise. To move left/down: Turn the POSITION knob counterclockwise. To select a line to move: Press the PUSH SEL. button. Each time you press the button, the selected line changes in the following order. L line R line H line L+R line • When you select a line while both Group A and B are displayed, the selection is performed for Group A first, and then for Group B. • When both L and R lines are selected, the lines cannot be moved separately. • Pressing and holding the PUSH SEL. button for 3 seconds or longer resets the displayed lines to the default positions. Grid mode The grid lines appear, which measure the visual difference. Pixels/Percentage between the grid lines Center window ● The following two types of the grid mode display are available: Normal display and Center window display. You can change the display by pressing the SELECT button. Normal display Center window display ● The width of the grid line can be changed. Turning the POSITION knob enlarges/reduces the width based on the upper left of the screen as the datum point. To enlarge: Turn the POSITION knob clockwise. To reduce: Turn the POSITION knob counterclockwise. Reduce the width Enlarge the width ● The ratio of the difference between the grid lines to the horizontal pixels appears in the percentage display. ● Pressing and holding the PUSH SEL. button for 3 seconds or longer resets the grid width to 100 pixels (default). ● When "L. INTENSITY" under the MAIN MENU "3D SETTING" is set to "LOW", the grid line is displayed translucent. 17