JVC GR-SX851U Instruction Manual - Page 38

38 EN USING THE REMOTE CONTROL UNIT (GR-SXM320/SX851 ony) (cont.) Insert Editing You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged. NOTE: Use the RM-V700U remote control unit to perform this procedure. Power Switch COUNTER R/M Button 1 Set the Power Switch to "PLAY". 2 Play back the tape, locate the Edit-Out point and press PAUSE. Display w M- 0 : 1 2 : 3 4 Insert editing indicator Tape Counter 3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press again for less than 1 second so that "M" appears. 4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the Edit-In point where the new scene should start. Remote sensor 5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step. 6 To begin Insert Editing, press START/STOP. When the counter reaches "0:00:00", editing stops automatically and the camcorder enters the Insert-Pause mode. 7 To end Insert Editing, press STOP. START/STOP REW PLAY PAUSE STOP INSERT NOTES: ● During Insert Editing, the original audio will be heard from the speaker. ● After step 5, Retake (੬ pg. 19) can be performed. ● The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. ● Only the video signal is recorded in the Insert Editing mode. RM-V700U (optional)