JVC KW-NX7000BT Instructions - Page 3

ENGLISH WARNINGS: To prevent accidents and damage • DO NOT install any unit or wire any cable in a location where; - it may obstruct the steering wheel and gearshift lever operations. - it may obstruct the operation of safety devices such as air bags. - it may obstruct visibility. • DO NOT operate the unit while driving. If you need to operate the unit while driving, be sure to look around carefully. • The driver must not watch the monitor while driving. • If the parking brake is not engaged, "Parking Brake" flashes on the monitor, and no playback picture will be shown. - This warning appears only when the parking brake wire is connected to the parking brake system built in the car (refer to the Installation/Connection Manual). [European Union only] Notes on the SD slot for System updating: The SD slot marked below is for System updating. To update the System, ☞ page 18. • Do not remove the cover in any case other than updating the System. SD slot for system updating For safety... • Do not raise the volume level too much, as this will block outside sounds, making driving dangerous. • Stop the car before performing any complicated operations. Temperature inside the car... If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes normal before operating the unit. Every time you turn on the unit or attach the monitor panel with the ignition switch turned on, the screen below appears. Pay sufficient attention when operating the unit and make sure of safe driving. How to reset your unit • Your preset adjustments will also be erased. How to forcibly eject a disc Press and hold OPEN/TILT while holding /ATT. [Hold] [Hold] • If this does not work, reset the unit. 3 INTRODUCTION