Kenmore 9787 Use and Care Guide - Page 12
Kenmore 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer Manual
View all Kenmore 9787 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
For mobile home use Gas dryers must be securely fastened to the floor at the time of installation. 1. 2. 3. Install exhaust hood. Use caulking compound to seal exterior wall opening around exhaust hood. Connect vent to exhaust hood. Vent must fit inside exhaust hood. Secure vent to exhaust hood with 4" (10.2 cm) clamp. Run vent to dryer location. Use the straightest path possible. See "Determine vent path" in "Plan Vent System." Avoid 90 ° turns. Use clamps to seal all joints. Do not use duct tape, screws or other fastening devices that extend into the interior of the vent to secure vent. Mobile home installations require a Mobile Home Installation Kit. For more information, please call 1-800-4-MY-HOME ® (1-800-469-4663). Check the levelness of the dryer. Check levelness first side to side, then front to back. Excessive Weight Hazard dryer. Use two or more people to move and install Failure to do so can result in back or other injury. 1. To protect the floor, use a large flat piece of cardboard from the dryer carton. Place cardboard under the entire back edge of the dryer. Firmly grasp the body of the dryer (not the console panel). Gently lay the dryer on the cardboard. See illustration. If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. 2. 1= Remove the red cap from the gas pipe. Using dryer. flared there a wrench to tighten, connect the gas supply to the Use pipe-joint compound on the threads of all nonmale fittings. If flexible metal tubing is used, be sure are no kinks. 2. A ... 3. Examine the leveling legs. Find the diamond marking. 4. Screw the legs into the leg holes by hand. Use a wrench to finish turning the legs until the diamond marking is no longer visible. Place a carton corner post from dryer packaging under each of the 2 dryer back corners. Stand the dryer up. Slide the dryer on the corner posts until it is close to its final location. Leave enough room to connect the exhaust vent or gas line. A. Flared male fitting B. Non-fiared male fitting 5. NOTE: For LP gas connections, you must use pipe-joint compound resistant to the action of LP gas. Do not use TEFLON °t tape. 1-®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company• 12