Kenmore 9787 Use and Care Guide - Page 23
Kenmore 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer Manual
View all Kenmore 9787 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Vacation care Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should: 1. 2. 3. Unplug dryer or disconnect power. Close shutoff valve in gas supply line. Clean lint screen. See "Cleaning the Lint Screen." Moving 1. 2. 3. 4. 5. 6. care The dryer light automatically you open the door. turns on inside the dryer drum when To change the drum light 1. Unplug dryer or disconnect 2. power. Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover. Unplug the power supply cord. Close shutoff valve in gas supply line. Disconnect gas supply line pipe and remove fittings attached to dryer pipe. Cap the open fuel supply line. Make sure leveling legs are secure in dryer base. Use masking tape to secure dryer door. 3. Turn bulb counterclockwise. Replace the bulb with a lO-watt appliance bulb only. Replace the cover and secure with the SCreW. 4. Plug in dryer or reconnect power. TROUBLESHOOTING First try the solutions suggested here and possibly avoid the cost of a service call... Dryer will not run • Has a household fuse blown, or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Was a regular fuse used? Use a time-delay fuse. Is the dryer door firmly closed? Was the Start button firmly pressed? Large loads may require pressing and holding the Start button for 2-5 seconds. • Unusualsounds Has the dryer had a period of non-use? If the dryer hasn't been used for a while, there may be a thumping sound during the first few minutes of operation. is it a gas dryer? The gas valve clicking is a normal operating sound. Is a coin, button, or paper clip caught between the drum and front or rear of the dryer? Check the front and rear edges of the drum for small objects. Clean out pockets before laundering. Are the four legs installed, and is the dryer level front to back and side to side? The dryer may vibrate if not properly installed. See the Installation Instructions. • is the clothing knotted or balled up? When balled up, the load will bounce, causing the dryer to vibrate. Separate the load items, and restart the dryer. • No heat Has a household fuse blown, or has a circuit breaker tripped? The drum may be turning, but you may not have heat. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. • Is the valve open on the gas supply line? • Dryer displaying code message "PF" (power failure), check the following: Was the drying cycle interrupted by a power failure? Press and hold START to restart the dryer. "F" Variable (F1, F2, F20) service codes: Call for service. • 23