Kenmore 9787 Use and Care Guide - Page 15

3.

Remove

existing

label from the opposite

side of the door

and

discard.

Find label provided

with the Use and Care Guide and

apply

over original

hinge

holes.

1.

Check

that all parts

are now installed.

If there is an extra part,

go back through

the steps

to see which

step was skipped.

2.

Check

that you have all of your

tools.

3.

Check

the dryer's

final location.

Be sure the vent is not

crushed

or kinked.

4.

Check

that the dryer is level. See "Level Dryer."

4.

Align the door by placing

the locating

tabs on the hinge with

the locating

holes on the dryer front

panel.

Insert and tighten

the center

hinge screw. The door will hang in place while

you

insert

and tighten

the remaining

4 screws.

NOTE:

Two or more people

may be needed

to reattach the

dryer door.

C

A. Dryer

door

B. Dryer

front panel

C. Insert this hinge

screw

first.

5.

Close the door and check

that it latches

securely.

6.

Check

for fingerprints

on the glass. Clean the glass if

necessary.

Electrical

Shock

Hazard

Plug

into

a grounded

3 prong

outlet.

Do not remove

ground

prong.

Do not use

an adapter.

Do not

use an

extension

cord.

Failure

to

follow

these

instructions

can

result

in

death,

fire,

or electrical

shock.

5.

6.

7.

8.

9.

10.

11.

Plug into a grounded

3 prong

outlet.

Turn on power.

Remove

any protective

film or tape

remaining

on the dryer.

Dispose

of/recycle

all packaging

materials.

Read "Dryer

Use."

Wipe the dryer drum

interior

thoroughly

with a damp cloth to

remove

any dust.

Select

a Timed

Dry heated

cycle,

and start the dryer. Do not

select the Air Only Temperature

setting.

If the dryer will not start,

check

the following:

•

Dryer is plugged

into a grounded

3 prong

outlet.

•

Electrical

supply

is connected.

•

Household

fuse is intact

and tight,

or circuit breaker

has

not tripped.

•

Dryer door is closed.

When the dryer has been running

for 5 minutes,

open

the

dryer door and feel for heat.

If you feel heat, cancel

cycle and

close

door. If you do not feel heat, turn off the dryer and

check that the gas supply

line shutoff

valve

is open.

•

If the gas supply

line shutoff

valve is closed,

open

it, then

repeat

the 5-minute

test as outlined

above.

•

If the gas supply

line shutoff

valve

is open, contact

a

qualified

technician.

15

Kenmore 9787 Use and Care Guide - Page 15

Kenmore 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer Manual

Page 15 highlights