Kenwood DNN770HD User Manual - Page 71
Car type setup DNN990HD, DSP select DNN990HD - bypass
View all Kenwood DNN770HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Return to the Top page Audio Setting Up Crossover network setup You can set a crossover frequency of speakers. 1 Touch the speaker to set the crossover in the Speaker Select screen. 2 Touch [X'over]. X'over screen appears. 3 Set each item as follows. ÑÑCar type setup (DNN990HD) You can setup the car type and speaker network, etc. 1 Touch [Car Type] in the Audio SETUP screen. Car Type screen appears. 2 Select your car type from the list. TW (Tweeter) Gain *1 (DNN990HD) Adjust the tweeter level. (When front is selected on Speaker Select screen) Gain (DNN990HD) Adjust the front speaker, rear speaker, or subwoofer level. Phase *2 Set the phase of subwoofer output. The phase is reversed 180 degrees when set to "Reverse". (When subwoofer is selected on Speaker Select screen) HPF FREQ High Pass Filter adjustment. (When front or rear speaker is selected on Speaker Select screen) LPF FREQ Low Pass Filter adjustment. (When subwoofer is selected on Speaker Select screen) Slope *3 (DNN990HD) Set a crossover slope. *1 Only when "Tweeter" is set to "Small", "Middle", "Large" in . *2 Only when "Subwoofer" is set to a mode other than "None"/"OFF" in . *3 Only when "LPF FREQ"/"HPF FREQ" is set to a mode other than "Through" in