Kyocera KM-6030 Scan System (G) Operation Guide (Setup Edition) - Page 38

Performing the Required Operation at the Scanner Notes • You can change the scan settings as desired by simply performing the corresponding setting procedure on the scanner's operation panel. • If you perform the same settings both from your computer and at the scanner itself, the specific settings made at the scanner will take priority. If you want to change any of the file information that you registered, press [Try again input data]. Ready to scan. Place originals then press Start key. Database Connection Original A4 08/25 Dest. of input data Program 02 Try again input data Auto Select Orig.Size Auto size Select Send Size B as ic Rear Orig. Set Direction 300dpi Scanning Resolution Quality 11 Once the scanning operation is data complete'key. Data sending will start. complete, the following screen will be ethod to continue displayed. If there are no more originals ction to be scanned, press [Input data complete]. ta: delivery • If you are using the PDF Keyword How-continue Same mode input data Assist option, the file information that you just registered will be Sel.folder input data Input of new data added to the scanned image data A file and that file will be saved into the designated folder. 08/25/`04 18:31 Cancel Input data complete • If you are using the Database Assist option, the file information that you just registered will be saved as a csv file and that file will be saved together with the scanned image data file into the designated folder. Note • If you want to use the Database Connection function once again, press [Sel.folder input data] and perform the procedure from step 4 on page 28. • If you want to use the Database Connection function once again, and at the same settings, press [Same made input data] and perform the procedure from step 6 on page 28. • If you want to use the Database Connection function once again, and under the same option (PDF Keyword Assist vs. Database Assist), press [Input of new data] and perform the procedure from step 5 on page 28. 30