Lenovo 9935B3U User Manual - Page 32
Installing, drive
UPC - 884343247403
View all Lenovo 9935B3U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Installing a drive in bay 1 Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support To install an optical drive or an additional hard disk drive in bay 1: 1. Remove the computer cover. See "Removing the computer cover" on page 14. 2. Access the system board. See "Accessing the system board components and drives" on page 15. 3. If you are installing a drive with accessible media, such as an optical drive, remove the plastic panel in the front bezel by squeezing the plastic tabs that secure the panel on the inside of the front bezel. 4. Remove the metal shield from the drive bay. 5. For a 5.25-inch drive, install a retaining bracket on the side of the drive. Note: If you are installing a 3.5-inch hard disk drive, you must use a Universal Adapter Bracket, 5.25 to 3.5-inch. You can obtain this bracket from a local computer retailer or by contacting the Customer Support Center. Figure 16. Retaining bracket 6. Align the drive bay assembly with the two slots and rails on the sides of the chassis, and install the drive into the drive bay until it snaps into position. Note: When installing the Universal Adapter Bracket, if the retaining bracket is not available, install the screws to secure the Universal Adapter Bracket into the drive bay. Figure 17. Installing the drive 7. Connect the new drive cable on the system board. See "Connecting a SATA drive" on page 25. 24 User Guide