Lenovo 9935B3U User Manual - Page 36
Replacing, optical, drive
UPC - 884343247403
View all Lenovo 9935B3U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
6. Reconnect the signal and power cables to the rear of the hard disk drive. 7. Position the hard disk drive and bracket so that it engages the retaining clips in the bottom of the chassis when you slide the bracket to the right. 8. Slide the hard disk drive and bracket to the right until it snaps into position. 9. Go to "Completing the parts replacement" on page 37. Replacing the optical drive Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support This section provides instructions on how to replace the optical drive. To replace the optical drive: 1. Remove the computer cover. See "Removing the computer cover" on page 14. 2. Remove the front bezel and drive bay assembly. See "Accessing the system board components and drives" on page 15. 3. Disconnect the signal and power cables from the rear of the optical drive. 4. Release the optical drive by pressing inward on the blue retainer at the side of the drive. 5. Slide the optical drive being replaced out the front of the drive bay assembly. Figure 23. Removing the optical drive 6. Remove the retaining bracket from the failing optical drive and install it on the new optical drive. Figure 24. Retaining bracket for the optical drive 28 User Guide