Lenovo 9935B3U User Manual - Page 33
Connecting, drive, Installing, diskette
UPC - 884343247403
View all Lenovo 9935B3U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Connecting a SATA drive A SATA optical drive or a SATA hard disk drive can be connected to any available SATA connector. To connect a SATA drive: 1. Locate the signal cable that comes with the new drive. 2. Locate the available SATA connector on the system board. See "Locating parts on the system board" on page 11. 3. Connect one end of the signal cable to the drive and the other to the available SATA connector on the system board. 4. Locate one of the extra five-wire power connectors and connect it to the drive. Figure 18. Connecting a serial ATA drive What to do next: v To work with another option, go to the appropriate section. v To complete the installation, go to "Completing the parts replacement" on page 37. Installing a diskette drive in bay 3 Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support To install a diskette drive in bay 3: 1. Remove the computer cover. See "Removing the computer cover" on page 14. 2. Access the system board. See "Accessing the system board components and drives" on page 15. 3. Remove the metal shield from the diskette drive bay by using a flat-blade screwdriver to gently pry it loose. 4. Remove the plastic panel in the front bezel by squeezing the plastic tabs that secure the panel on the inside of the front bezel. 5. Install a retaining bracket on the side of the diskette drive. Figure 19. Retaining bracket Chapter 2. Installing options and replacing hardware 25