Lexmark 11C0200 Service Manual - Page 73

Jam 202 The paper has exited the fuser but not the printer. FRU 1 Fuser Sensor (PC9) Paper Exit Sensor (PC8) Fuser Assembly Action Go to the "Sensor Service Check" on page 2-47 and check the fuser sensor (PC9) and actuator. If it is working correctly, return to this check. Go to the "Sensor Service Check" on page 2-47 and check the paper exit sensor (PC8) and actuator. If it is working correctly, return to this check. Check the fuser belts and the fuser lower roller for wear or damage. If it is not operating correctly, replace the fuser assembly. This is a customer replaceable part at prescribed intervals. Check the paper exit rollers for dirt or damage. Replace as necessary. 2 3 4 Paper Exit Rollers Toner Cartridge Rack Service Check FRU 1 • Rack Motor (M3) • Mechanical Controller Board (PWB-A) • Toner Cartridge Rack Latch Gears • Rack Home Position Sensor (PC4) • Mechanical Controller Board (PWB-A) Action Be sure the rack motor (M3) turns during a print cycle. If it does not, replace the motor. If you still have the problem, replace the mechanical controller board. 2 Check the latch for wear or damage. 3 4 If the toner cartridge rack does not turn during a print cycle, check the gears for overload. Use the sensor check test to check the rack home position sensor (PC4). If it does not operate correctly, replace the sensor (PC4). If it operates correctly, replace the mechanical controller board. 2-38