Lexmark W812 Setup Guide - Page 27

Loading 500sheettrays, Make sure the paper is under both

Get Lexmark W812 PDF manuals and user guides View all Lexmark W812 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Loading 500-sheet trays Follow these instructions to load A4 or letter size paper into a 500-sheet tray, depending on which tray you purchased. Do not exceed the recommended capacity (see page 15). 1 Remove the tray, and then set it on a flat surface. 2 Remove the tray cover. Make sure all packing materials have been removed from inside the tray. 3 Flex the sheets of paper back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the edges of the stack on a level surface. 4 Place the paper against the back of the tray, print side up. Make sure the paper is under both corner bucklers and lying flat in the tray. 5 Replace the tray cover. 6 Insert the tray. 7 Select the paper type and paper source from the operator panel. You will also need to select the paper size, type, and source from your software application when you send a job to print. Load paper 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
21
Load paper
Loading
500-sheet trays
Follow these instructions to load A4 or
letter size paper into a 500-sheet tray,
depending on which tray you purchased.
Do not exceed the recommended
capacity (see page 15).
1
Remove the tray, and then set it
on a flat surface.
2
Remove the tray cover.
Make sure all packing materials
have been removed from inside
the tray.
3
Flex the sheets of paper back and
forth to loosen them, and then fan
them.
Do not fold or crease the paper.
Straighten the edges of the stack
on a level surface.
4
Place the paper against the back
of the tray, print side up.
Make sure the paper is under both
corner bucklers and lying flat in
the tray.
5
Replace the tray cover.
6
Insert the tray.
7
Select the paper type and paper
source from the operator panel.
You will also need to select the
paper size, type, and source from
your software application when
you send a job to print.