Marantz AV8003 AV8003 User Manua - Page 51
Tuner Operation
View all Marantz AV8003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
OTHERS TROUBLESHOOTING REMOTE CONTROLLER ADVANCED OPERATION BASIC OPERATION SETUP CONNECTIONS NAMES AND FUNCTION ENGLISH RECOVERY OF MEMORY Recover backed up settings as follows. Hold the MEMORY and MENU buttons on the front panel simultaneously for at least 3 seconds. STANDBY POWER ON/OFF INPUT SELECTOR PURE DIRECT M-DAX AV PRE TUNER AV8003 UP HDMI DOWN VOLUME SURROUND MODE AUTO PURE DIRECT PHONES ZONE THX ZONE SPEAKER 7.1CH INPUT SETUP MIC MENU EXIT ENTER BAND T-MODE MEMORY CLEAR TOP M-DAX DISPLAY "MEMORY LOAD" is displayed and the unit's stored settings are reapplied. The unit temporarily enters standby mode. If there is no backup data, "NO BACKUP" is displayed and no data is recovered. MEMORY LOAD NO BACKUP Note: • Because the following settings values are not backed up, each Volume value is set to Minimum. • Main Zone Volume • Zone Volume • Zone Speaker Volume TUNER OPERATION 3. 3. TO SELECTING THE TUNER (Using the unit) STANDBY POWER ON/OFF INPUT SELECTOR PURE DIRECT M-DAX AV PRE TUNER AV8003 UP HDMI DOWN VOLUME SURROUND MODE AUTO PURE DIRECT PHONES ZONE THX ZONE SPEAKER 7.1CH INPUT SETUP MIC MENU EXIT ENTER BAND T-MODE MEMORY CLEAR TOP M-DAX DISPLAY 2. ≠ 2. 1. 4. 4. To select TUNER, turn the INPUT SELECTOR knob on the front panel. (Using the remote controller) There are three ways to select TUNER. 1. Press the HOME button. 2. Press the < / > button until 002 is displayed. 3. Press the 4.TUNER button. 4. Press the 4.TUNER button. 1. 2. 2. 2. 1. Press the HOME button 2. Press the 4 button. 1. ≠ 4. 4. 48 3. 3. 1. Press the HOME button. 2. Press the AMP button. 3. Press the < / > button until 008 is displayed. 4. Press the TUNER button. LISTENING TO THE TUNER AUTO TUNING 1. 3. 2. STANDBY POWER ON/OFF INPUT SELECTOR PURE DIRECT M-DAX AV PRE TUNER AV8003 UP HDMI DOWN VOLUME SURROUND MODE AUTO PURE DIRECT PHONES ZONE THX ZONE SPEAKER 7.1CH INPUT SETUP MIC MENU EXIT ENTER BAND T-MODE MEMORY CLEAR TOP M-DAX DISPLAY 3. 3. 2. 2. 4. 4. (Using the unit) 1. Turn the INPUT SELECTOR knob to select "TUNER". 2. Press the BAND button to select either FM or AM. 3. Press the 3 or 4 cursor buttons on the front Panel for more than 1 second to start the auto tuning function. 4. Automatic searching begins then stops when a station is tuned in. (Using the remote controller) 1. Switch the remote controller to TUNER mode. 2. Press the < / > button until 001 is displayed. 3. Press the FM or AM button. 4. Press and hold the 3 or 4 cursor button for 1 second or more. 5. Automatic searching begins then stops when a station is tuned in.