Marantz AV8003 AV8003 User Manua - Page 54
Name Input Of The Preset Station., Sorting Preset Stations
View all Marantz AV8003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
SORTING PRESET STATIONS STANDBY POWER ON/OFF INPUT SELECTOR PURE DIRECT M-DAX AV PRE TUNER AV8003 UP HDMI DOWN VOLUME SURROUND MODE AUTO PURE DIRECT PHONES ZONE THX ZONE SPEAKER 7.1CH INPUT SETUP MIC MENU EXIT ENTER BAND T-MODE MEMORY CLEAR TOP M-DAX DISPLAY If you have stations memorized, and there is a gap in the sequential order: I.e. the stations are stored as follows 1) 87.1 MHz 2) 93.1 MHz 3) 94.7 MHz 10) 105.9 MHz (notice there is no stations programmed for pre sets for 4-9), you can have pre set 10 become pre set 4: To sort the numbers, press the 4 cursor button while holding down the MEMORY button. "PRESET SORT" will appear on the display and sorting will be done. NAME INPUT OF THE PRESET STATION. This function allows the name of each preset channel to be entered using alphanumeric characters. Before name inputting, you need to store preset stations with the preset memory operation. 4. 5. 2. 5. 6. STANDBY POWER ON/OFF INPUT SELECTOR PURE DIRECT M-DAX AV PRE TUNER AV8003 UP HDMI DOWN VOLUME SURROUND MODE AUTO PURE DIRECT PHONES ZONE THX ZONE SPEAKER 7.1CH INPUT SETUP MIC MENU EXIT ENTER BAND T-MODE MEMORY CLEAR TOP M-DAX DISPLAY 2.5.6. 2.5.6. 4. 5. 5. 4. 1. Recall the preset number to be inputted name with the method described in "Recalling" a preset station. 2. Press the MEMORY button on the front panel or press the MEMORY button on the remote controller for more than 3 seconds. 3. The left most column of the station name indicator flashes, indicating the character entry ready status. 4. When you press the 3 or 4 cursor buttons on the front panel or the 3 or 4 cursor buttons on the remote controller, alphabetic and numeric characters will be displayed in the following order: A → B → C ... Z → 1 → 2 → 3 ..... 0 Blank) → A UP → → DOWN 5. After selecting the first character to be entered, press the MEMORY or ENTER button, or press the MEMORY button on the remote controller. The entry in this column is fixed and the next column starts to flash. Fill the next column the same way. To move back and forth between the characters, press the 1 / 2 cursor buttons on the front panel or the remote controller. Note: • Unused columns should be filled by entering blanks. 6. To save the name, press the MEMORY or ENTER button on the front panel, or press the MEMORY button on the remote controller for more than 2 seconds. Instead of using the 3 and 4 cursor buttons or the on the front panel remote controller to select characters, characters can be input from the numeric keys of the remote controller. See the below table for a correspondence between characters and numeric keys. Ten keypad 1 2 3 4 5 6 7 8 9 0 Press, press again, press again, etc. A → B → C → 1 → A D → E → F → 2 → D G → H → I → 3 → G J → K → L → 4 → J M → N → O → 5 → M P → Q → R → 6 → P S → T → U → 7 → S V → W → X → 8 → V Y → Z → space → 9 → Y 0 ENGLISH 51 OTHERS TROUBLESHOOTING REMOTE CONTROLLER ADVANCED OPERATION BASIC OPERATION SETUP CONNECTIONS NAMES AND FUNCTION