Marantz AV8003 AV8003 User Manua - Page 90

NAMES AND FUNCTION LCD (LCD setting) Press the button next to the "LCD" indicator in the SYS.SETUP menu screen in the LCD. The LCD setting menu is displayed. ENGLISH 3. The message "COMPLETED" is displayed on the LCD to indicate that the display time setting is completed. • CONTRAST (LCD CONTRAST ADJUSTMENT) This enables the LCD contrast to be adjusted. Adjust for maximum visibility according to your viewing environment. 1. The LCD setting menu is displayed, and so press the buttons next to "CONTRAST" in the LCD display. 2. Press the side buttons (right: +, left: -) to adjust the contrast level. BEEP (Beep sound setting) This sets the built-in beep sound in the RC2001. 1. Press the button next to the "BEEP" indicator in the SYS.SETUP menu screen in the LCD to display the beep setting screen. 2. Press the button next to the "ENABLE" or "DISABLE" indicators on the LCD to either enable or disable the beep sound. CONNECTIONS SETUP BASIC OPERATION ADVANCED OPERATION • LCD TIMER (LCD timer setting) This sets the time that the LCD remains on, after a button is pressed on the RC2001. When there are no operations and the LCD is turned off, this setting enables power consumption to be reduced and the life of the battery pack to be extended. The default setting is 10 seconds. 1. The LCD setting menu is displayed, and so press the button next to "LCD TIMER" in the LCD display. 2. Press the buttons (right: +, left: -) displayed next to TIME to set the display time. The time can be set in 1-second intervals from 10 to 60 seconds. To leave the LCD always on, press the button next to the "ALWAYS ON' indicator. However, please note that this setting will shorten the life of the battery pack. After deciding the settings, press the ENTER button. • Either press the ENTER button or wait three seconds for the LCD to automatically return to the SYS.SETUP menu. • Pressing the Home button returns the LCD to the MAIN MENU. Note: If the LCD is turned off by the LCD timer, pressing any of the buttons on the remote controller will turn it on again. When the LCD is turned on, the pressed command is not activated. To execute a command operation, press the button while the LCD is on. After deciding the settings, press the ENTER button. The message "COMPLETED" is displayed on the LCD to indicate that the setting is completed. 3. Either press the ENTER button or wait three seconds so that "ENABLE" or "DISABLE" is displayed on the LCD and the settings are automatically completed. • Either press the ENTER button or wait three seconds for the LCD to automatically return to the SYS.SETUP menu. • Pressing the Home button returns the LCD to the MAIN MENU. • Either press the ENTER button or wait three seconds for the LCD to automatically return to the SYS. SETUP menu. • Pressing the Home button returns the LCD to the MAIN MENU. REMOTE CONTROLLER TROUBLESHOOTING OTHERS 87