Motorola WR850G User Guide - Page 14
LED Description - password
UPC - 612572095027
View all Motorola WR850G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Section 1 Overview LED Description LED 1 Power 2 Modem 3 Wireless Condition ON ON OFF ON/Blinking ON/Blinking OFF ON/Blinking Color Green Red None Amber Green None Green Status The device is powered on and operating normally. The Power LED turns RED as soon as the reset button is depressed. If the reset button is held down, the LED starts to blink RED and the router's username, password, private LAN IP address, private subnet mask address and operation mode are restored to factory default settings. If the Power LED stays RED for longer than 5 seconds, this indicates that the firmware is corrupted and needs to be restored. The device is not powered on. 10BaseT link detected / active traffic present. 100BaseT link detected / active traffic present. No external Ethernet device has been attached and detected. The Ethernet link may be down. The wireless interface is enabled / active traffic present. NOTE: The wireless LED does not blink on WR850G "Version 1" hardware. You can determine your version of hardware by looking at the product label on the bottom of the router. Within the box that includes the FCC logo, a "Version 1" unit will display "MODEL: WR850G", while a "Version 2" unit will display "MODEL: WR850Gv2" (see example below). MODEL WR850G INPUT VOLTAGE: +5VDC, 2A PART NUMBER: AAAAAA-BBB-CC FCC ID: F2NWR850G S/N: PPPPMMYJJJSSSSSCAABBCCCC MODEL: WR850G Tested To Comply With FCC Standards FOR HOME OR OFFICE USE WIRELESS MAC: AB CD EF 01 23 45 WAN MAC: AB CD EF 01 23 45 MADE IN TAIWAN 4 LAN (x4) OFF ON/Blinking ON/Blinking OFF None Amber Green None The wireless interface is not enabled by the firmware. 10BaseT link detected / active traffic present. 100BaseT link detected / active traffic present. No external Ethernet device has been attached and detected. The Ethernet link may be down. 1-8 WR850