Nokia 002M1S1 E72 User Guide - Page 114
Sensor settings, Security settings, Device and SIM card security
UPC - 758478018279
View all Nokia 002M1S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Settings To set the device to answer phone calls automatically after 5 seconds when an accessory is attached, select the accessory and Automatic answer > On. If the ringing type is set to Beep once or Silent in the selected profile, automatic answering is disabled. To illuminate the device while it is attached to an accessory, select Lights > On. This option is only available for certain accessories. Sensor settings Select Menu > Ctrl. panel > Settings and General > Sensors. To set the device to silence an incoming call or snooze an alarm when you turn the device face down, select Turning control. Security settings Security settings Select Menu > Ctrl. panel > Settings and General > Security. Select from the following: • Phone and SIM card - Modify the security settings for your device and SIM card. • Certificate management - Manage your security certificates. • Protected content - Modify your settings for DRMprotected content. • Security module - Manage your security module. 114 Avoid using codes that are similar to emergency numbers to prevent accidental dialling of the emergency number. Codes are shown as asterisks. When you change a code, enter the current code, then the new code twice. Device and SIM card security To change the PIN code, select Phone and SIM card > PIN code. The new code must be 4 to 8 digits long. The PIN code protects your SIM card against unauthorised use and is provided with the SIM card. After three consecutive incorrect PIN code entries, the code is blocked, and you need to use the PUK code to unblock it before you can use the SIM card again. To set the keypad to lock automatically after a defined period, select Phone and SIM card > Keypad autolock period. To set a time-out after which the device is automatically locked and can be used only if the correct lock code is entered, select Phone and SIM card > Phone autolock period. Enter a number for the time-out in minutes, or select None to set off the autolock period. When the device is locked, you can still answer incoming calls, and calls may still be possible to the official emergency number programmed into your device. To set a new lock code, select Phone and SIM card > Lock code. The preset lock code is 12345. Enter the current code and then the new code twice. The new code can be 4-255 characters long. Both alphabets and digits can be used, and both uppercase and lowercase alphabets are possible. The device notifies you if the lock code is not properly formatted.