Pentax 645 645 Manual - Page 52
Dedicated, Flash, Precautions
View all Pentax 645 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Common use for TTL auto and external auto flash modes Flash synchronization at a slower speed: In Metered manual mode, the shutter speed in the area of 1/125 sec. through 1/1000 sec. will automatically switch to 60 (1/60 sec.) with the completion of flash charging. All speeds slower than 1/60 sec. can be used for flash synchronization according to the requirements, thus permitting flash photography with synchronization at a slower shutter speed. Simultaneously with the completion of flash charging, the marking indication will appear in the external LCD and within the viewfinder's LED. Auto flash confirmation mark In each of the photographic modes, the auto flash confirmation marking will appear. Should the flash photography take place within the flash coupling range of the TTL auto flash units (TTL and the Programmed auto flash units), the s marking on the viewfinder's LED display will be lit or will flicker immediately following flash discharge, which indicates "auto flash confirmation". Its appearance assures that proper flash exposure has been rendered to the subject. Flash coupling range to activate the auto flash confirmation mark may vary depending upon certain limitations according to the subject situation. With the AF200T, the auto flash confirmation is also signified by an audible buzzing. 50 DEDICATED FLASH PRECAUTIONS • When setting the flash mode selector to MS (Manual synch.) or to the M (Manual) position utilizing a dedicated auto flash unit, adjust the aperture to the respective f/stops. The same procedure must apply to multiple flash operation. Setting to the "A" position will not provide proper exposure. The functions of the MS or M may vary depending upon the type of dedicated auto flash unit in use. It is recommended that the flash unit instructions be read and followed for optimum results. • TTL and external auto flash operation is possible at 60 (1/60 sec. fixed) or B. When the shutter speed has been set at the B position, the B shutter speed will not switchover to that of flash synchronization, even when flash charging has been completed. • Should the power switch of a dedicated flash unit be kept ON, the power source timer for the camera's exposure meter will be kept turned ON. Once the charging process has been completed, do not fail to turn the flash unit's power switch to the OFF position as soon as the flash is no longer required.