Pioneer DV-C36 Owner's Manual - Page 25

GETTING STARTED USING YOUR DVD PLAYER 5 Resuming Playback from Where You Stopped - DVD/Video CD Use the resume feature to restart playback from the point that the disc was stopped last time. Press STOP 7 once. The display shows "RESUME" and the stop position is memorized. • The resume position remains memorized as long as the disc is in the play position - even if you switch the power off. If you change the disc in the play position or start playing another disc, however, the resume position is lost. • Pressing STOP 7 twice causes the disc to return to the beginning when PLAY 3 is pressed again. The display shows the disc type (DVDs or Video CDs) Press PLAY 3. Playback starts from the resume position. Notes • The actual restart position may be slightly before or after the resume position. • If you want to remove or change the disc, but still want to resume playback from the last stopped position, use the LAST MEMORY feature instead (page 52). Stopping Playback and Switching Power Off - DVD/Video CD/CD 4 1 4 LAST MEMORY LAST CONDITION MEMORY COND. OPEN/ CLOSE 0 AUDIO SUBTITLE ANGLE DISPLAY DISP SETUP VNR MENU 5 TOP MENU RETURN 5 ENTER PREV 4 5 STOP 7 PLAY 3 STEP/SLOW REV e E 1 1 2 3 NEXT ¢ PAUSE 8 FWD ¡ CLEAR C 4 5 6 +10 7 8 PROGRAM REPEAT 9 0 A-B SEARCH MODE 3 2 2 DVD PLAYER STANDBY/ON CD MODE FL DIMMER REFERENCE DVD PLAYER DISC 1 2 3 4 5 0 OPEN/CLOSE DISC SKIP EXCHANGE DVD 41 ¡¢ 7 8 3 13 1 Press STOP 7 (7 on the front panel). Playback stops. 2 Press OPEN/CLOSE 0 (0 OPEN/CLOSE on the front panel). • The disc tray comes out. • The tray rotates and the disc that was playing is located towards the front of the table. 3 Remove the disc. • If you want to remove more discs, press DISC SKIP to rotate the disc tray. 4 Press ( STANDBY/ON on the front CAUTION: When moving the unit When changing places of installation or packing the unit for moving, be sure to remove all discs and return the disc table to its original position in the player. Then, press STANDBY/ON and switch the power to standby. Check that the "--OFF--" indication on the display goes off, then disconnect the power cord. Moving this unit with the disc loaded may result in damage to this unit. panel). The disc tray goes back in. 25