Pioneer PRO110FD Owner's Manual - Page 24
Adjust the position of the speaker and then
UPC - 012562864976
View all Pioneer PRO110FD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
05 Preparation 2 Screw a supplied screw into the speaker mounting hole (lower of the two) at the top, rear of the display. • Do not tighten it all the way yet. Leave it loose, with about 5 mm left to tighten. 4 Adjust the position of the speaker and then tighten the upper screw firmly. 5 Tighten all screws firmly, thus fixing the speakers to the display. Speaker mounting hole Top, rear of display Top of display 5 mm Leave a space of about 5 mm 3 Hang the speaker mounting fitting on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the lower screw temporarily. After passing the wide part of the hole of the speaker mounting fitting (top) over the screw, lower the speaker onto it. 6 Pass the supplied speaker cable between the speaker and the plasma display (below the speaker mounting fitting) from below. 7 Connect the speaker cables to the speaker (see next page). 8 Insert the cable in the groove on the speaker. Speaker cable Speaker terminal After passing the wide part of hole over the screw, lower the speaker. Insertion in groove Tighten with the provided screw the bottom speaker mounting fitting to the display temporarily (one place bottom). 9 Connect the other end of the speaker cables to the rear of plasma display (see next page). 24 En