Ricoh 3245 Operating Instructions - Page 36

Copying Copying from the Bypass Tray Use the bypass tray to copy onto spe- ❒ The maximum number of sheets cial paper such as OHP transparen- you can load at one time depends cies, thick paper, thin paper, and copy on paper type. The maximum paper that cannot be loaded in the pa- number of sheets should not exceed 2 per trays. Preparation the upper limit. ❒ Some kinds of envelopes might When copying from the bypass tray, select [1 Sided] for copying in [Dup./Combine/Series] (for example [1 Sided] → [1 Sided].) cause misfeed and wrinkle. If this happens, push down the fusing unit's green lever. See p.26 "When Copying onto Envelopes". Also, be sure to place the front face of the Note envelope downward. ❒ The machine can automatically de- ❒ Paper of 433 mm in length, or larg- tect the following sizes as standard er, is likely to jam, crease, or not size copy paper: feed in properly. Metric A3L, A4L, A5L, B4 JISL, version B5 JISL, B6 JISL Inch 11" × 17"L, 81/2" × 11"L, version 51/2" × 81/2"L ❒ Select the paper size when making horizontal copies. ❒ The print speed when copying onto OHP transparencies or thick paper is slower than when copying onto plain paper. A Open the bypass tray. ❒ If you use non-standard size copy paper or special paper, you should input its vertical and horizontal dimensions directly. See p.17 "Placing custom size originals". The sizes you can input are as follows: Metric • Vertical: 90.0 - 305.0 mm version • Horizontal: 148.0 - 457.2 mm Inch • Vertical: 3.55" - 12.00" version • Horizontal: 5.83" - 18.00" ZKVH120J ❒ When copying onto OHP transparencies or paper heavier than 128 g/m2 (about 34 lb.), you need to specify the paper type. See p.24 "When copying onto OHP Transparencies or Thick Paper". ❒ You must specify the paper size when using paper (tracing paper, etc.) of less than 59g/m2 thickness. 22