Ricoh 3245 Printer Reference - Page 21

Setting Paper on the Bypass Tray B Adjust the paper guides to the pa- per size. Important ❒ If the paper guides are not flush against the paper, skewing and misfeeds might occur. C Gently insert paper face up into the bypass tray until the beeper sounds. AEU011S 1. Extender 2. Paper guides Note ❒ The beeper will not sound if it is turned off. Gently insert paper until it stops. ❒ Do not stack paper over the limit mark, otherwise a skewed image or misfeeds might occur. ❒ Open out the extender to support paper sizes larger than A4 L, 81/2"×11" L. ❒ Fan the paper to get air between the sheets to avoid a multi-sheet feed. ❒ When setting an OHP transparency, make sure that its front and back sides are properly positioned. ❒ Select paper type when printing onto OHP transparencies or thick paper (over 127.9 g/m2). For details, see p.17 "Setting thick paper or OHP transparencies". D Select the paper size. Note ❒ You can set paper size using the printer driver. The following 1 procedures are not necessary when setting paper size using the printer driver. ❒ The paper size set using the printer driver has priority over that set using the display panel. ❒ When the printer driver is not used, make settings using the display panel. ❒ Thick paper and OHP transparencies are delivered face up on the top of the preceding page; therefore, the prints need to be rearranged into the correct order. To avoid this, select [Reverse order print] in the RPCS printer driver settings to deliver the prints in the correct page order. Reference For printer driver settings, see the printer driver Help. For details about setting custom sizes, see p.16 "Setting custom size paper". A Press the {User Tools/Counter} key on the control panel. AEU035S B Press [System Settings]. 15