Samsung NQ70CG600DSRAA User Manual - Page 68
English, Using the gliding rack, DO NOT spray or allow
View all Samsung NQ70CG600DSRAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Maintaining your appliance Maintaining your appliance To lubricate the slides of the gliding rack 1. Remove the rack from the oven. See removing the gliding rack in the Using the gliding rack section on page 56. 2. Fully extend the rack on a table or countertop. Newspaper may be placed underneath the rack for easy cleanup. 3. If there is debris in the slide tracks, wipe it away using a paper towel. (Any graphite lubricant wiped away must be replaced - See steps 4 through 7). 4. Shake the graphite lubricant before opening it. Starting with the left (front and back) slide mechanism of the rack, place four (4) small drops of lubricant on the two (2) bottom tracks of the slide close to the bearing carriers. Oven door 68 English 5. Repeat for the right (front and back) slide mechanism of the rack. 6. Open and close the rack several times to distribute the lubricant. 7. Replace the cap on the lubricant and shake it again. Turn the rack over and repeat steps 3, 4, 5, and 6. 8. Close the rack, turn the rack rightside-up, and then place in oven. See Installing the Gliding rack on page 56. NOTE Do not spray the gliding rack with cooking spray or other lubricant sprays. Don't hand • clean the oven door gasket. You may hand clean the door. • Use soap and water to thoroughly clean the top, sides, and front of the oven door. Rinse well. You may use a glass cleaner on the outside glass of the oven door. DO NOT immerse the door in water. DO NOT spray or allow water or the glass cleaner to enter the door vents. DO NOT use oven cleaners, cleaning powders, or any harsh abrasive cleaning materials on the outside of the oven door. DO NOT clean the oven door gasket. The oven door gasket is made of a woven material which is essential for a good seal. Care should be taken not to rub, damage, or remove this gasket.