Sanyo PLC XE40 Owners Manual - Page 54
Cleaning the Air Filters, We recommend avoiding dusty/smoky environments - lcd projector
View all Sanyo PLC XE40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Maintenance and Cleaning Cleaning the Air Filters Air filters prevent dust from accumulating on the optical elements inside the projector. Should the air filters become clogged with dust particles, it reduces cooling fans' effectiveness and may result in internal heat build up and adversely affect the life of the projector. Clean the air filters following the steps below. 1 Turn off the projector, and disconnect the AC power cord from the AC outlet. 2 Turn over the projector and remove the air filters by pulling the latches upward. 3 Clean the air filters with a brush or rinse them softly. 4 When cleaning the air filters by rinsing, dry them well. Replace the air filters properly. Make sure that the air filters are fully inserted. CAUTION Do not operate the projector with the air filters removed. Dust may accumulate on the optical elements degrading picture quality. Do not put small parts into the air intake vents. It may result in malfunction of the projector. RECOMMENDATION We recommend avoiding dusty/smoky environments when operating the projector. Usage in these environments may cause poor image quality. When using the projector under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector. This condition may degrade the quality of a projected image. When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning. Air filters Pull up and remove. ✔Note: • When reinserting this air filter, be sure that the slit part is facing the outer side. Attaching the Lens Cover When moving the projector or the projector is not in use, 1 replace the lens cover. 1 Thread the string through the hole on the lens cover and then tie a knot. 2 Thread the other end of the string through the hole on the bottom of the projector. Then pass the lens cover through the resulting loop and pull it to tighten the 2 knot. 54