Sony MZ-NH900 Operating Instructions - Page 93
While using group function, While the recorder is connected to the computer
View all Sony MZ-NH900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Symptom Tracks cannot be combined. The disc cannot edit on other component. Cause/Remedy • This is due to the MiniDisc system limitations. When the tracks are scattered and the length of each track is short*, you may not be able to combine the tracks. * Combining tracks of the following lengths may not be possible. Hi-MD mode Linear PCM stereo: 9 seconds or less Hi-SP stereo: 8 seconds or less Hi-LP stereo: 32 seconds or less MD mode SP stereo: 12 seconds or less LP2 stereo/Monaural: 24 seconds or less LP4 stereo: 48 seconds or less • You cannot combine tracks recorded in different recording modes, e.g., a track recorded in stereo and a track recorded in monaural; nor can you combine a track recorded with digital connection and a track recorded with analog connection. • The component does not support MDLP or Hi-MD. , Edit on other component that support MDLP or Hi-MD. While using group function Symptom Cause/Remedy The group function • While using a disc without group setting, an attempt was made to select does not operate. some group-related menu. , Use a disc with group setting. A track cannot be recorded to a new group. A new group cannot be created. • This is due to the MiniDisc system limitations (in MD mode only). Group information has been written to the area where the disc name is stored. The disc name and track names are recorded in the same area, which can store a maximum of approximately 1,700 characters. If the total number exceeds this amount, a new group cannot be created even though group mode is on. It is also impossible to make group settings at this time. While the recorder is connected to the computer Symptom The recorder is not recognized by the computer. Cause/Remedy • The dedicated USB cable is not firmly connected. , Connect the dedicated USB cable firmly to the recorder and the computer. • A USB hub is used. , Connect the dedicated USB cable directly to the USB port of the computer. • Network communication has failed. , Disconnect the dedicated USB cable, wait at least 2 seconds, and then reconnect it. If the recorder is still not recognized, disconnect the dedicated USB cable, restart the computer, and then connect the dedicated USB cable again. 93