Sony RM-VL900 Operating Instructions (primary manual) - Page 25
keys, press S set to finish - how to program remote
View all Sony RM-VL900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
4 Press the button(s) for the desired operation. The selected Component button lights up every time you press a function button, and turns off when you release it. 5 Repeat Steps 3 and 4 to program the buttons for the series of operations. In this example: Press the following buttons. 1 Power on the TV 5 Set the input mode of the TV to VIDEO 6 Start video playback 2 Power on the video 3 Power on the amplifier 4 Set the input mode of AMP to VIDEO 1 6 When you have programmed all function keys, press S (set) to finish setting. Notes • If you interrupt the procedure at any point for over 10 seconds, the setting mode ends and the series of commands will be programmed to that point. In this case, clear the program (page 26) and start again from Step 1 to set the entire program from the beginning. You cannot continue from where you let off. • If a SYSTEM CONTROL button has already "learned" a remote control signal (see page 35), you cannot program on this button. Clear the "learned" contents first (see page 26). • If you change the component code number (page 8) or program a new signal by Learning (page 15) on a button that has been programmed in the series of commands of the System Control function, the new signal will be transmitted when you press the corresponding SYSTEM CONTROL button. • If you have programmed an incorrect operation by mistake, press S (set) to cancel setup and start again from Step 1. Continued 25