Sony RM-VL900 Operating Instructions (primary manual) - Page 9

3 Press the Component Select button for the desired component. The selected Component button lights up, and all other buttons turn off. 4 Press the Number buttons to enter the three-digit component code number. The selected Component button turns off each time you press a Number button. Notes • If you press a component code number that is not on the table in the supplied "Component Code Numbers", or if you press a button in an improper order, the Component button flashes five times, and then turns off. Check the component code number, and try setting again. • If you don't input anything into the Commander for over 20 seconds between each step, the setup procedure will be canceled. To set the code, start over from Step 2. • If you press S (set) while setting the component code, all code numbers will be lost, and the setup procedure will be canceled. Start over from Step 2. To cancel setup, press S (set). 5 Press ENT. The Component button turns off. If the Component button flashes five times before turning off, it means that the setup is incomplete. Start over from Step 2. Continued 9