Sony RM-VL900 Operating Instructions (primary manual) - Page 26
While holding S set, pressed, press one of the, SYSTEM CONTROL 1, 2, or, button. - reset
View all Sony RM-VL900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Executing a Series of Commands - System Control Function (continued) Tips for programming the System Control function The following information helps you to program a consecutive operation steps. About the interval between operation steps You can change the interval between operation steps (see page 29). About the order of operation steps • Some of the components may not accept consecutive remote control signals. For example, a TV generally does not react to a next signal right after the Power-on signal. So, a series of commands such as TV Power-on and input select may not work properly. In this case, insert other signals like the example below; TV Power-on t VCR Power-on t VCR play back t TV input select • By programming an often-used component's command as the final step, you can save the step of pressing a Component Select button when you start operating that component. To clear programmed commands While holding S (set) pressed, press one of the SYSTEM CONTROL 1, 2, or 3 button. All Component Select buttons light up when you press these buttons, and turn off when you release them. To set the SYSTEM CONTROL 1 or 3 button back to the factory setting At the factory, the SYSTEM CONTROL 1 button is preset with the System Power-Off function for Sony components, and the SYSTEM CONTROL 3 button is factory preset with standard power-on command for nearly all Sony components. To reset them to the factory settings, clear the "learned" commands on the SYSTEM CONTROL 1 or 3 button. The System Control functions will be restored. 26