Sony RM-VL900 Operating Instructions (primary manual) - Page 40
Receiving the data
View all Sony RM-VL900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Transferring Data between Remote Commanders (continued) 5 Press ENT (Start data transfer). After the data is transferred, the Component Select button turns off. If data transfer has been unsuccessful during or after procedure, the S (set) indicator and the selected Component button flashes five times, and the Commander returns to its state in Step 3. Either try again from Step 5, or press S (set) to cancel data transfer. Notes • The data of the "learned" signal and the System Control function programmed on a Component Select button cannot be transferred. You can use the Learning function (page 15) to program the "learned" signal and the System Control function programmed on a Component Select button on another remote commander. • Be sure that the receiving remote commander is ready to receive data. Receiving the data This Commander can receive the data of another Sony RM-VL900 or RM-AV2100. To receive the all data from another remote commander 1 Place the RM-VL900 head to head with another remote commander. Another remote commander about 2 - 4 inches (5 - 10 cm) away RM-VL900 2 Press and hold S (set) for more than 3 seconds. The S (set) indicator lights up, and all Component Select buttons flash. 40