Sony RM-VL900 Operating Instructions (primary manual) - Page 42
Press ENT.
View all Sony RM-VL900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Transferring Data between Remote Commanders (continued) To receive the data of the Component Select button from another remote commander 5 Press ENT. The S (set) indicator lights up and the selected Component button turns off (data-reception standby). 1~2 Perform Steps 1 to 2 on page 40. 3 While holding cursor V pressed, press the Component Select button to which want to set the data. The S (set) indicator flashes, and the selected Component button lights up. 6 Press ENT (ENTER) on the sending remote Commander. After the data is received, the Component Select button lights up. If data transfer has been unsuccessful during or after the procedure, both the S (set) indicator and the Component button flash five times, and the Commander returns to its state in Step 5. Either try again from Step 6, or press S (set) to cancel data receival. 4 Confirm that the sending remote commander is ready for data transfer. (To set the sending commander, follow the procedure on page 39.) Note Be sure that the sending remote commander is ready to transfer data. Note If you do not perform Step 6 within 10 seconds, the S (set) indicator and the Component Select button flash five times, followed by a short pause, and then flash again. 42