Sony RM-VL900 Operating Instructions (primary manual) - Page 41
Press ENT ENTER on
View all Sony RM-VL900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3 While holding cursor V pressed, press the Number 1 button. The S (set) indicator flashes and all Component Select buttons light up. 6 Press ENT (ENTER) on the sending remote Commander. As the data is received, the corresponding Component Select buttons light up one by one. If data transfer has been unsuccessful during or after the procedure, the S (set) indicator and all Component Select buttons flash five times, and the Commander returns to its state in Step 5. Either try again from Step 6, or press S (set) to cancel data receival. 4 Confirm that the sending remote commander is ready for data transfer. (To set the sending commander, follow the procedure on page 38.) Note Be sure that the sending remote commander is ready to transfer data. 5 Press ENT. The S (set) indicator lights up and all Component Select buttons turn off (data-reception standby). Note If you do not perform Step 6 within 10 seconds, the S (set) indicator and all Component Select buttons flash five times, followed by a short pause, and then flash again. Continued 41