Sony RM-VL900 Operating Instructions (primary manual) - Page 39
Press ENT Start data
View all Sony RM-VL900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
4 Confirm that the receiving remote commander is ready to receive data. (To set the receiving commander, follow the procedure on page 40.) Note Be sure that the sending remote commander is ready to transfer data. 5 Press ENT (Start data transfer). As the data is transferred, the corresponding Component Select buttons turn off one by one. If data transfer has been unsuccessful during or after procedure, the S (set) indicator and all Component Select buttons flash five times, and the Commander returns to its state in Step 3. Either try again from Step 5, or press S (set) to cancel data transfer. To transfer the data of a Component Select button The data of a Component Select button on this Commander (the settings and "learned" signals programmed on the buttons) can be transferred to a Component Select button on another Sony RM-VL900 or RM-AV2100. 1~2 Perform Steps 1 to 2 on page 38. 3 While holding cursor v pressed, press the Component Select button whose data you want to send. The S (set) indicator flashes and the selected Component button lights up. Notes • The data for the functions not available with the RM-AV2100 cannot be transferred. The System Control functions cannot be transferred to another kind of Commander even if it has the mark. • Be sure that the receiving Commander is ready to receive data. 4 Confirm that the receiving remote commander is ready to receive data. (To set the receiving commander, follow the procedure on page 42.) Note Be sure that the sending remote commander is ready to transfer data. Continued 39