Sony STR-DA2100ES Operating Instructions for STRDA2100ES - Page 58

6 Press the appropriate button on the remote control to be learned to send the remote button code. Lightly pressing the button once should be sufficient. If learning is completed successfully, the indicator slowly flashes twice and the remote automatically exits the learning mode. When learning is not completed successfully, the indicator flashes 4 times in quick succession and the procedure returns to step 6. If the memory of the remote is already full, the indicator flashes 8 times in quick succession and the remote automatically exits the learning mode. Notes • You can program more than 80 keys for the Learning function. In some cases, you may not be able to program even if you have not programmed 80 buttons. The number of buttons you can program for each input button are shown in the following table. Input Number of Buttons you can program VIDEO 1, VIDEO 2, DVD 78 keys VIDEO 3, TV/SAT, TAPE 78 keys MD/DAT, SA-CD/CD, 78 keys TUNER PHONO, MULTI CH 52 keys TV buttons, (TV ?/1, 7 keys TV VOL +/- , TV CH +/-, WIDE, TV/VIDEO • In steps 2 and 4, the indicator turns off while a valid button is pressed. • In step 4, if several buttons that can be used for learning are pressed, only the last pressed button is valid. The indicator flashes slowly, it turns ON while a valid button is pressed. • In step 6, if a button that can be used for learning is pressed, the new button is selected and the learning procedure returns to the beginning of step 6. To activate the input source after programming Press the programmed button to activate the input you want. To cancel learning Press RM SET UP during any step. The remote automatically exits the learning mode. To clear the learned codes Start over from step 1. After step 4, press TV ?/1 for more than 2 seconds. The indicator lights up twice slowly and the learned code is cleared. If TV ?/1 is pressed less than 2 seconds, the learning procedure returns to the beginning of step 6. When a learned code is cleared, if the button was previously programmed for another input selector, the programmed code for that button can be used. To clear the memory of the remote To clear all programmed and learned signals, do the following to reset the remote to factory settings. Press ?/1, AV ?/1 and MASTER VOL - at the same time. The indicator flashes 3 times, then goes off. To use a command that has been learned When selecting a learned input, press the learned button for that input. 58US