Toshiba Portege M100 User Manual - Page 86

Operating Basics FingerPrint Power-on Security General The FingerPrint authentication system can be used to replace the keyboard based password authentication system that is used when the computer is turned on. If you do not want to use the FingerPrint authentication system for password authentication when the computer is turned on, but instead prefer to use the keyboard entry method instead, simply press the BkSP (backspace) key or the ESC/Rotation button when the FingerPrint Power-on Security screen is displayed. Using this process will switch the password input screen across to the keyboard based entry screen. ■ You must ensure that you use the TOSHIBA Password Utility to register a User Password before using the FingerPrint Power-on Security and its extended function to allow FingerPrint to be used to access the computer when it is turned on. ■ If the FingerPrint authentication process fails five times, a preset time limit is exceeded, or you press the BkSP (backspace) key, [Password=] will be displayed on the screen and you will have to enter either the User Password or Supervosor Password manually in order to start the computer. ■ When swipe your finger, please ensure you do it slowly and at a constant speed. If you find that this does not improve the authentication rate, you should try to adjust the speed at which the finger is swiped. ■ If there are any changes in the environment or setting related to authorization, you will be required to provide authorization information such as a User Password (and, if applicable, the HDD (Hard Disk Drive) password). How to Enable FingerPrint Power-on Security Settings It is necessary to first enroll your FingerPrint with the Protector Suite QL application prior to enabling and configuring the FingerPrint Power-on Security System. You should check that your FingerPrint is enrolled before configuring the settings (please refer to the Manual for FingerPrint Registration/Enrollment for further instructions.) 1. Swipe your finger across the FingerPrint Sensor. 2. MENU will appear in the lower right corner of the screen. Swipe(*) your finger on the FingerPrint sensor and then select Control Center from the items presented in this menu (*) It is recommended that the keyboard cursor keys (movement) and enter key (selection) or the directional pad be used when selecting and item from the Menu in laptop or landscape modes. 3. At the FingerPrint Software Management screen, click Settings and then click Power-on Security. 4. At the Power Security screen, place a check mark in the Replace the power-on and hard disk drive passwords with the FingerPrint reader setting and then click OK. 4-8 Satellite M100