Vtech LS6381-2 Users Manual - Page 9

Install the battery Charge the battery 1. Plug the battery connector securely into the socket inside the handset battery compartiment. • Make sure the battery label THIS SIDE UP is facing up, as indicated. 16 hrs THIS SIDE UP OéOReUnPPcUEhINiRSnCCSeTEEURMR4EEL2NE(BTS2A.:TP4sITV:LE3ER0SI.0EmS.AhCNiÔ-TMÉH)VERS LE HAUT CR2105 MadeN iEnPDCAOhSi INnWaNOA/CTIRFNBNaIÉUbNrBRBRiGTaEqNt/1tRu6eOéA2rOVR3eyUE4nPP2RP/cUaTEhBcINikTRSTnC/2CSeTH6IEEBU2lSR3MRo4EcELS-2INEp(BiTSDl2A.:eETP4sITV:LUE3EPR0SI/.0EmSC.AEhCNiÔ-TMÉH)VERS LE HAUT CR2105 The following table summarizes the battery indicators and actions to take. 2. Align the cover flat against the battery compartment, then slide it upwards until it clicks into place. Battery indicators • The screen is blank, or Battery status • The battery has no Action • Charge without shows Put in charge or interruption charger and very little (at least 30 flashes. charge. The minutes). handset cannot be used. • The screen shows Low battery and flashes. • The battery has enough charge to be used for a short time. • Charge without interruption (at least 30 minutes). • The screen shows HANDSET X. • The battery is • To keep charged. the battery charged, place it in the handset charger when not in use. When it is fully charged, you can expect Check for dial tone the following performance: Operation • Operating time * Talk time (cordless • 10 hours handset) Standby • 5 days Lift the corded handset, or press HOME/FLASH on the cordless handset. If you hear a dial tone, the installation is successful. * Operating times vary depending on your actual use and the age of the battery. If you do not hear a dial tone • Make sure the installation procedures are properly done. • The handset may take a second or Check the battery level two to find the telephone base and produce a dial tone. This is normal. After you have installed the battery, Wait an extra second before dialing. check the battery level on the handset • If the previous suggestions do not screen. work, disconnect the telephone • If the screen is blank, or flashes, then line cord from your telephone and the battery needs to be charged. Go connect the telephone line cord to to Charge the battery section before another telephone. you do any setting or operation. • If there is no dial tone on that other • If the battery icon is , , or , then telephone either, your telephone go to Set the date and time, Set line cord may be defective. Install a Smart call blocker through voice new telephone line cord. guide and Set the answering system • If changing the telephone line through voice guide section. cord does not help, the wall jack (or the wiring to this wall jack) may be defective. Try using a different wall jack in your home to connect your LS6381/LS6381-2/LS6381-3/ LS6381-4/LS6381-5/LS6382/LS6382- 2/LS6382-3/LS6382-4/LS6382-5/ VS324/VS324-2/VS324-3/VS324-4/ VS324-5 telephone, or contact your telephone service provider (charges may apply). 16 17