Whirlpool WFC8090GX Installation Instructions - Page 16
Water Inlet Hose, Removing The Load & Go, Bulk Container, Non-use And Vacation Care, Winter - installation
View all Whirlpool WFC8090GX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
CLEAN WASHER CYCLE REMINDER The Clean Washer with affresh® message will flash at the end of a wash cycle when the washer has run 30 wash cycles. This is a reminder to run the Clean Washer with affresh® cycle. If the Clean Washer with affresh® cycle is not run, the message will stop flashing at the end of a wash cycle after running three more regular wash cycles. After 30 more wash cycles are completed, the Clean Washer with affresh® message will again flash at the end of a wash cycle as a reminder. REMOVING THE LOAD & GO™ BULK CONTAINER To remove: 1. Lift the bulk container lid on the top of the washer/dryer. 2. Lift up on the bulk container handle and pull straight up and out of the washer/dryer. To replace: 1. Place the bulk container back into the bulk container cavity on the top of the washer/dryer and make sure that it is seated. 2. Close the bulk container lid. NON-USE AND VACATION CARE If moving, or not using your washer/dryer for a period of time, follow these steps: 1. Unplug or disconnect power to washer/dryer. 2. Turn off water supply to washer/dryer to avoid flooding due to water pressure surges. HELPFUL TIP: Attach a reminder note to the washer/ dryer to turn the water back on before washer's next use. 3. Clean the bulk dispenser. See "Cleaning the Load & Go™ Bulk Dispenser." WINTER STORAGE CARE IMPORTANT: To avoid damage, install and store washer/ dryer where it will not freeze. Because some water may stay in hoses, freezing can damage washer/dryer. If storing or moving during freezing weather, winterize your washer/dryer. To winterize washer/dryer: 1. Shut off water faucet, disconnect and drain water inlet hose. HELPFUL TIP: Attach a reminder note to the washer/ dryer to turn the water back on before washer's next use. 2. Remove drain pump filter. 3. Put 1 qt. (1 L) of R.V.-type antifreeze in drum and run washer on Normal cycle for about 2 minutes to mix antifreeze and remaining water. 4. Unplug washer/dryer or disconnect power. WATER INLET HOSE Replace inlet hose after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hose if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hose: ■■ Mark the date of replacement on the label with a permanent marker. ■■ Check that the old washer is not stuck on the washer inlet valve. ■■ Use a new washer in the new inlet hose to ensure a proper seal. 16