Whirlpool WFC8090GX Installation Instructions - Page 44
Manually Unlocking the Door
View all Whirlpool WFC8090GX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Manually Unlocking the Door HOW TO MANUALLY OPEN DOOR (cont.) 2. Pull down on the plastic strap located beneath the removed screw. The door can now be opened and the laundry removed, if needed. HOW TO MANUALLY OPEN DOOR Before opening the door as described below, refer to the failure "Door will not unlock" in the "Troubleshooting" section. The door may unlock by itself after the failure condition no longer exists. If the door still cannot be opened, perform the following: Before Opening Door: n Turn off and unplug the washer/dryer. n Close the water faucet. n Wait until the drum has stopped rotating - never open the door while the drum is in motion. n Wait until water and laundry have cooled down when washing with high temperatures. Always drain the water before opening the door by: n Following the instructions in the "Cleaning the Drain Pump Filter/Draining Residual Water" section. To Unlock and Open Washer/Dryer Door: 1. Open the drain pump filter access door at the bottom right corner at the front of the washer/dryer. With a Phillips head screwdriver, loosen and remove the Phillips head screw at the upper right portion of the access door compartment. 3. After removing laundry (if needed), secure the plastic strap by replacing and tightening the Phillips head screw removed in Step 1 through the hole in the strap. 44