Whirlpool WFC8090GX Installation Instructions - Page 17
Cleaning The Drain Pump Filter, Draining Residual Water Cont., Draining Residual Water - w collection
View all Whirlpool WFC8090GX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CLEANING THE DRAIN PUMP FILTER/ DRAINING RESIDUAL WATER (cont.) 3. Lay a cotton cloth beneath the drain pump filter to absorb any water still in it. Then remove the drain pump filter by turning it counterclockwise. CLEANING THE DRAIN PUMP FILTER/ DRAINING RESIDUAL WATER NOTE: Perform the following procedure every 6 months. 1. Open the drain pump filter access door at the bottom right corner at the front of the washer/dryer. 4. Remove large clumps of lint by hand from the filter and place lint in a suitable waste container. Remove remaining residue from the filter by rinsing with water. 2. Place a broad, flat pan beneath the drain pump filter to collect the drain water. Pull out the black hose, remove the plug, and drain the hose into the pan. Empty the pan. Replace the drain hose plug and put the hose back into place. Repeat this procedure if necessary until all the water has drained. Make sure that the black hose is completely dry. Black hose 5. Reinsert the drain pump filter by turning it clockwise. Make sure to turn it in as far as it will go, with the filter handle left in a vertical position. 17